Backflow Prevention

● Suitable for use where air gap or air break is required in sealed or unvented systems.

● Backflow preventer with multifunction geometry
● BA type
● Dezincification resistant alloy body
● Threaded union connections
● For linear installation on horizontal or vertical pipes
● Complete with strainer at the inlet
● Max working temperature: 65°C
● Certified to BS EN 12729 standard

● Dezincification resistant brass alloy
● Yellow brass finish to body
● Max working pressure: 10 bar
● Max working temperature: 60°C

The Altecnic range of BA type backflow prevention devices designed for applications in water distribution systems to prevent back siphonage and back flow in fluid category 4 applications.

● Max pressure at inlet: 10 bar
● Max working temperature: 65°C
● Complete list of spares available
● Includes RPZ, isolation valve and strainer

The ‘BA” Backflow Preventer is a verifiable mechanical device designed to prevent contamination of the wholesome water by either back-siphonage due to a reduced or negative pressure in the mains water supply or system back pressure from the water installation within the premises.The device consists of an arrangement of water fittings within three pressure zones having different obturators and a dump valve.When backflow or back pressure conditions occurs the device provides an atmospheric separation between the wholesome water system and the contaminated fluid.

Where can the ‘BA” Backflow Prevention device be Used?

Proper use of the BA type backflow preventer is regulated by the European standard on prevention of pollution from backflow. The relevant standard is BS EN 1717:2000 ‘Protection against pollution of potable water in water installations and the general requirements of devices to prevent pollution by backflow’. The types of water contained in water systems are classified in this standard according to the degree of risk to health.